|
Post by 67roguexcode on Jul 5, 2023 8:04:09 GMT -8
It was great to finally meet you...
|
|
|
Post by amxdreamer on Jul 5, 2023 8:09:18 GMT -8
Congratulations. Looks like you did the 15 minute 401 swap. interceptor baby!!!! lol Joe noticed a little piece missing so Rick helped me out. It might not be 100% correct BUT at least it has the Zeeeeeeeeeeeeeeee
|
|
|
Post by landbarge on Jul 5, 2023 8:21:50 GMT -8
Always have to peek under the skirt for the real answer.
|
|
|
Post by amxdreamer on Jul 5, 2023 9:40:49 GMT -8
that's how life is nowadays! lol
|
|
|
Post by amxdreamer on Feb 27, 2024 9:17:36 GMT -8
The latest project was some new stainless trim for the tops of the doors. The ones on the car have some good sized dings and dents that bothered me. A friend in Quebec had a full set on his parts car and sent them west to me. This is a good project because I needed to buy a new tool! The small hammer worked much better than my bigger hammer/dolly set. After watching a few youtube videos I started in on the new trim. No major damage but a few dings and scratches to clean up. Some hammer work and then the file to see high and low spots followed with some more hammer work. Lots of sanding starting at 180 and ending up with 2000 grit. Now I just need to get them installed without dinging or scratching anything!
|
|
|
Post by n2ojoe on Feb 27, 2024 11:16:39 GMT -8
Those look great!! I need to try and learn this on an extra set of Machine wheel trim rings I have.
|
|
|
Post by amxdreamer on Feb 27, 2024 15:11:08 GMT -8
Thanks Joe, I'm pleased enough with the results that I'm going to work on some trim for the AMX that isn't perfect. With the amount of time and work these were I couldn't image a set of trim rings! lol
|
|
|
Post by sc397 on Feb 27, 2024 16:39:10 GMT -8
Nice job!... I HATE working with stainless.
|
|
|
Post by amxdreamer on Feb 27, 2024 17:39:32 GMT -8
Nice job!... I HATE working with stainless. Thanks, and so do I. lol
|
|